[. . . ] ⷠIf the appliance is installed above drawers make sure that the space, between the bottom of the appliance and the upper drawer, is sufficient for air circulation. Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. ⷠKeep children and pets away from the appliance when it operates or when it cools down. [. . . ] Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If after some tries the burner does not light, check if the crown and its cap are in correct positions. Always turn the flame down or switch it off before removing the pans off the burner. Power indicator is activated when electric cooking zone is turned on, and will stay on until electric cooking zone is switched off. This is typical of all ceramic glass cooking zones and does not show that the appliance operates incorrectly. Set the maximum position and operate the appliance for approximately 10 minutes until water inside the pans boils. after that , operate the appliance at minimum position for 20 minutes. After this operation, clean the appliance with a soft cloth soaked in warm water. ⷠStop the electrical cooking zones before the end of the cooking time to use residual heat. ⷠThe bottom of pans and electrical cooking zones must have the same dimensions. ⷠThe bottom of the cookware must be as thick and flat as possible. ⷠWhen the liquid starts to boil, turn down the flame to barely simmer the liquid. Make sure pot handles do not protrude over the front edge of the cooktop and that pots are centrally positioned on the rings in order to achieve maximum stability and to obtain lower gas consumption. Do not place unstable or deformed pots on the rings to prevent from spill and injury. Liquids spilt during cooking can cause the glass to break According to the newest scientific knowledge, if you brown food (specially the one which contains starch), acrylamides can pose a health risk. Thus, we recommend that you cook at the lowest temperatures and do not brown food too much. Disconnect the appliance from the electrical supply before you clean or do maintenance work. It is best to clean the electrical cooking zone while it is still warm because you can remove spillage more easily. For your safety, do not clean the appliance with steam blasters or high-pressure cleaners. Scratches or dark stains on the surface have no effect on how the appliance operates. ⷠYou can remove the pan supports to easily clean the hob. ⷠTo clean the enamelled parts, cap and crown, wash them with warm soapy water and dry them carefully before you put them back. [. . . ] ⷠThe power cable must be placed in such a way that it does not touch any hot part. ⷠConnect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. ⷠNone of a parts of the connection cable can not get a temperature 90 °C. The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. [. . . ]